Re: [TenTec] orion vfo encoder

[Carl Moreschi <n4py3@earthlink.net>]

I just want to point out that my N4PY Orion program will control the 
Orion very well and make it so the VFO encoder is not needed at all.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 11/29/2018 3:14 PM, Barry N1EU wrote:
> FYI, I still have two Omni 6 VFO encoders left
>
> Bourns 128 PPR optical encoders - these are excellent replacements for
> failing Omni VI/VI+ tuning encoders, main or RIT.  They feature 1/4in
> shafts with 3/8 X 3/8 bushings which are what the Omni uses.  Model numbers
> as follows:
>
> ENA1J-C28-L00128 (Qty 1 available)
>
> ENS1J-B28-R00128 (Qty 1 available)
>
> Datasheet can be viewed here:
> https://www.mouser.com/datasheet/2/54/NC1J-777419.pdf
>
> New ones currently go for $51-$67.  I'm offering these for $25 shipped
> CONUS.  My understanding is that all of these will work well and are
> essentially interchangeable.
>
> Please respond via direct email.
>
> 73, Barry N1EU
>
> On Thu, Nov 29, 2018 at 7:55 PM Michael Tortorella<w2iy@verizon.net>  wrote:
>
> > Hi Gary, might you have any of these left?  I belatedly saw an eBay auction
> > for one but was too late to catch it.
> > Thanks and 73
> > Mike W2IY
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec