TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[TenTec] Omni VT L PF board

from [Malcolm McLeman] [Permanent Link][Original]
To: tentec@contesting.com
Subject: [TenTec] Omni VT L PF board
From: Malcolm McLeman <f5vbu@cegetel.net>
Date: Sun, 10 Mar 2019 11:06:04 +0100
List-post: <mailto:tentec@contesting.com>
The receive side of my O6 has packed in (yet again) and will no dubt requirea diode change on the LPF board. 
Duet to failing eyesight the task is becoming very onerous and as I have
a spare borad am seriously thinking of removing all the attentuator and au antenna architecture and going for simple relay type T/R wswitching. 
Is there a mod out there or has anyone attempted?
Grateful for any comments.
73
Malcolm F5VBU
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Omni VT L PF board, Malcolm McLeman <=
Previous by Date:  Re: [TenTec] Omni-C Power Switch Challenge, Wade Staggs
Next by Date:  [TenTec] Omni-C Power Switch Resolved!!...New Challenge, Jim C
Previous by Thread:  [TenTec] Question about the use of the RX antenna port present on some TT transceivers, Carlos
Next by Thread:  [TenTec] Omni-C Power Switch Resolved!!...New Challenge, Jim C
Indexes:  [Date] [Thread] [Top] [All Lists]