Not likely anything in the PTO would cause the S meter to fail to work.
The S meter plugs into the IF/AF board via connector 17. It is possible you
pulled this loose when you were working on the PTO.
Does the meter indicate anything in transmit?
Gary
> On Apr 10, 2019, at 9:48 AM, Lysle Anderson via TenTec
> <tentec@contesting.com> wrote:
>
> Hello to the group and good day.
> My Ten-Tec Argosy II needed a PTO cleaning and re-greasing. Although I had
> never attempted this before, there is lots of information available as to it
> is to be done. All went well and the PTO now works fine but the S meter now
> does not work. I re-checked the connections that I had previously unhooked
> and all seems correct. Is it possible that I forgot something in the PTO
> itself even though it itself seems to work OK? Thanks in advance.
> Lysle H AndersonVE1BZEKentville, Nova Scotia
> Canada.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|