| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Hercules II Power meter |
| From: | Gary Hendricks <k4mt1950@charter.net> |
| Date: | Sat, 1 Jun 2019 14:27:25 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I just acquired a Hercules II and the power meter lights the red bars at
about 400 watts. I looked at the control
board and saw an adj named bar. Is that the adjustment? Also saw two pots that say AGC. What are they for? Is there some specific procedure for adjusting bar graph? Amp does put out over 500 W and tests done into dummy load. Gary K4MT |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Omni VII Plus at Hamvention!, jon greenwood |
|---|---|
| Next by Date: | [TenTec] 565 Tuner battery, Keith Hanson |
| Previous by Thread: | [TenTec] Orion 565 Tuner battery?, Sandor Wetsel |
| Next by Thread: | Re: [TenTec] Hercules II Power meter, Ken Brown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |