I recently acquired a Hercules II Amp and the matching 9420 100 Amp power
supply. The power supply is supposed to power the Hercules II and the
Transceiver driving it. I’m really confused about the 4 pin molex connector
mounted on the front panel of the power supply that is supposed to power the
Transceiver. It looks like the standard connector Ten Tec has been using for
years to power their transceivers which you would normally short pins 2 & 3 to
turn the p.s. on. This one is labeled differently. Pin 1 – GND, Pin 2 – PWR ON,
Pin 3 – +13.5/LO I, Pin 4 - +13,5V/20A. I would like to power my Omni 7 or
Orion II with this connector. Can someone tell me how to wire this connector to
power these Transceivers? Any help would be greatly appreciated. Tks.
Ross Weston
W8REW
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|