Re: [TenTec] looking for the remote tuning pod that works with the jupiter

[Radio AI2Q <ai2q@roadrunner.com>]

Dale, you can make one using an optical encoder. Mine is mounted in a 
small box that sits on the operating table. It communicates with my 
Omni-V via a cable and the RS-232 connector on the back of the transceiver.
Vy 73, AI2Q, Alex



On 8/25/2019 12:38 PM, dale via TenTec wrote:
> HI
>   Looking for the above ten tec tuning pod that the jupiter and other ten tec 
> radios used. It was like the flex control used on flex radios.
> thanks for looking
> 73
> dale
> wt4t
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

---
This email has been checked for viruses by AVG.
https://www.avg.com