Remove the battery and install the new one. Be sure polarity is correct.
As to installing the tuner into your Orion II, radio power off, remove
the battery from the tuner to be installed, install the tuner in the
Orion II, install the battery in the tuner. Be sure polarity is correct
and the connectors are correctly and fully inserted.
73
Bob, K4TAX
On 10/4/2019 10:21 AM, Petr Ourednik wrote:
Hi folks,
I have just short question regarding the CR2032/2025 battery replacement in the
AT566K internal antenna tuner in O2...
Can I simply remove the old one and replace with new cell or should I bypass
the power pins with 3V PSU at first in order to not disconnecting the supply
voltage from the tuner board?
The similar question I have when I will be installing this tuner into my O2...
Should I install it with battery in or should I remove the battery during the
installation please?
(it is a bit contradicting to the first point, hihi)
Thanks for hints,
73 - Petr, OK1RP
http://ok1rp.blogspot.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|