| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] 1. Argosy 525D filters not working (lhilborn5) |
| From: | William Redfearn <n4elm@bellsouth.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 10 Oct 2019 19:12:17 +0000 (UTC) |
| List-post: | <mailto:tentec@contesting.com> |
Lynn, On the 525 (D), the Xtal switch only controls the accessory filter on the IF/AF board.The 220 (2.4) filter (if installed on the RF board) is inline all the time.The Xtal switch would be switching the 217 (500) in and out.Its possible you have bad connections on the IF/AF board or a bad crystal on the filter. Dave, N4ELM _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion Orion II A9 decoded, but not repaired yet, Gary Follett |
|---|---|
| Next by Date: | Re: [TenTec] Corsair SWR goes high as power is increased, Gary Follett |
| Previous by Thread: | [TenTec] Orion Orion II A9 decoded, but not repaired yet, Gary Follett |
| Next by Thread: | Re: [TenTec] Corsair SWR goes high as power is increased, Gary Follett |
| Indexes: | [Date] [Thread] [Top] [All Lists] |