| To: | "'tentec@contesting.com'" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] 253 autotuner stepper motor |
| From: | "Gary Hendricks" <k4mt1950@charter.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 06 Jan 2020 08:44:23 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Has anyone had a failure and found a sub for the stepper motor in the 253 autotuner? It has part number PF-42-48X4 18 ohm and no manuf stamp. I removed and disassembled /lubed roller inductor but motor still stalls at times. I have re-seated all connections on logic board but motor is intermittent. Voltage levels on logic board seem fine. Thanks K4MT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] TenTec Digest, Vol 205, Issue 5, AA2PM |
|---|---|
| Next by Date: | [TenTec] 253 autotuner stepper motor, Gary Hendricks |
| Previous by Thread: | Re: [TenTec] TenTec Digest, Vol 205, Issue 5, AA2PM |
| Next by Thread: | [TenTec] 253 autotuner stepper motor, Gary Hendricks |
| Indexes: | [Date] [Thread] [Top] [All Lists] |