Many thanks for the advice!
Terry, KI3C
On Sat, Mar 7, 2020 at 1:09 AM Malcolm McLeman <f5vbu@cegetel.net> wrote:
> Releasing PL14 should give you the movement you require Terry but would
> suggest for peace of mind to take the board out completely and to do
> this jobe and make sure it is well tethered with replacement screws when
> finished. GL
> Malcolm F5VBU
>
>
> On 3/7/2020 2:21 AM, Terry Berman wrote:
> > I need to attach a new coax cable between the PA and the LPF board. To
> do
> > this I need to get to the underside of the PA board. I've loosened all
> > the screws on the PA board to see if it would nudge up a little but it
> > seems very firmly attached. I want to avoid causing damage. Anyone done
> > this before and have some pointers?
> >
> >
> > Thanks,
> >
> > Terry Ki3C
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|