Change all of the electrolytic capacitors on the A9 board with low ESR 105C
rated capacitors.
Most Orion problems like this are caused by A9 board problems.
Gary
W0DVN
> On Apr 28, 2020, at 11:12 AM, hb9jnh <hb9jnh@bluewin.ch> wrote:
>
> Recently I acquired an Orion II with installed ATU. At the time of the
> handover I tested most of the functions and everything looked fine. Even the
> latest available firmware was installed. I used the Orion for several month
> without any problems, mainly with reduced power (20w). But suddenly
> following symptoms appeared:
>
> * After powering on (with normal behavior), Main and Sub RX sounding
> very deaf and when I push the TUNE button, the ALC light remains dark and no
> signal is transmitted.
>
> * When pushing the TUNE button or keying the transmitter in CW mode,
> the SWR shows always 1.0 : 1, regardless of whether an antenna is connected
> or not.
>
> * Symptoms remains on all bands, in any mods.
>
> * Relays during band switching, Side tone, keyer, filter etc. are
> working fine.
>
> After switching off and on again, the problems are gone. But it can happen
> while tuning over the band, the symptoms are appearing again. Sometimes
> after 10 minutes, sometimes not at all.
>
> After reading several information here in the forum, I tried following
> measures:
>
> * Made several resets (any kind of resets)
>
> * Replaced the SNAPHAT battery
>
> * Disconnected and cleaned every connector and ribbon cable
>
> But unfortunately, none of the measures solved the problem.
>
> Do you have any idea how I can isolate or solve the problem? Any help is
> appreciated.
>
> Best 73 de Markus, HB9JNH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|