Relays on the Low Pass Filter board may have an open coil. 10 & 12 share the
same filter section. Two relays per filter section, coils in parallel. Also I
recall a small RFC in series with the coil. I’ve see those open.
73
Bob, K4TAX
Sent from my iPhone
> On Jul 5, 2020, at 7:24 PM, Rodney Dewald via TenTec <tentec@contesting.com>
> wrote:
>
> Relays
>
> Sent from Mail for Windows 10
>
> From: Frank Sweeney
> Sent: Sunday, July 5, 2020 8:22 PM
> To: tentec@contesting.com
> Subject: [TenTec] Orion II No Output 10M and 12M
>
> I have no output on 10M and 12M Any thoughts on what to check 1st?
>
> thanks
> Frank K9IC
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|