Just connect the SDR receiver Ant to the 9 MHz IF output. The ACC1 is not
used. The USB connector goes to the computer. I use HDSDR software which
handles the SDR and the Argonaut from your computer.
Bob, K4TAX
Sent from my iPhone
> On Jul 16, 2020, at 11:02 PM, Chang Song <tru64ufs@gmail.com> wrote:
>
> Hello, folks.
>
> Anyone set up a panadpter for Tentec Argonaut VI?
> The back of the unit has ACC1, 9Mhz IF signal.
>
> best setup?
>
> --
> Chang Song
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|