Hi All
Now started work on my 2nd paragon:-
A: 1st indication is all the LED tell tales on the front panel are
illuminated, ( operating mode, filter selection etc) non will turn off,
no digits in the display there is however all the legends on the very
top of the display.
B: 2nd, on the Low Level Amp/noise blanker PCB, the MRF476 get hot very
quickly, this transistor is driven by a 2n3866, these have been known to
cause problems, i took it out and tested it, then compared the results
from the testing of another identical transistor, exactly the same,
that's either both good or both faulty!
C: Have changed c49,c52-54,c56 on the Logic Board just in case it was a
problem as advised on the 1st Paragon i worked on.
Have any of you learned gents met this problem before?.
Stay well and healthy
73
Snowy G0HZE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|