Mike for PTO parts check with Earl Andrews of Netty Electronics
He also has scrap rigs
Jim ve3ddy
--
Sent from myMail for Android Tuesday, 06 October 2020, 01:51PM -04:00 from Mike
Bryce prosolar@sssnet.com :
>I’ve always wanted to put in one of those DDS VFOs that run on 5.0 to 5.5 mhz.
>would make for an interesting project.
>there’s plenty of room behind the dial for an encoder. The only issue would be
>sometype of digital display (a Chinese digital dial comes to mind) to replace
>the analog dial
>( you didn’t say if the C21 was digital or not)
>
>Ten Tec used the basic PTO though out, there maybe one or that that were very
>model specific, but I’d guess to wager a PTO from triton 4, Omni A, B or C
>might work, too. But that’s only my guess
>
>mike, wb8vge
>“The trouble with quotes on the Internet is that you never know if they are
>genuine”
>
>—Abraham Lincoln
>
> On Oct 6, 2020, at 1:24 PM, David Goncalves < davegoncalves@gmail.com> wrote:
>
> I’m was trying to restore a really rough Century/21, but have already run
> into a snag. It appears somebody has worked on the PTO and left parts out.
> I’m missing the wedge (90254), one of the washers (51006) and the pistol
> (80263P) and pin (38025) are damaged. This looks bad enough to consider
> junking, given how bad other parts are on the rig. Perhaps somebody has a
> failed Century/21 on the list in good mechanical order, or these parts to
> spare?
>
> Thanks,
>
> David Goncalves
> W1EUJ
> --
> David Goncalves
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|