My thanks to Barry, Bob, and Carl for helping me sort out the panadaptor
options for my Orion. I finally got some radials down yesterday for the new
vertical so we are getting closer to getting back on the air and needing the
panadaptor. I plan to pull the covers off the Orion and check the backup
battery and the A9 board caps before firing it up again after a 2-year
hiatus.
BTW, I made a mistake when I said I have an SDR-Play. What I actually have
is an RTL-SDR, I don't know if this make a lot of difference but this at
least corrects the error.
Thanks again and 73, Mike W2IY
-----Original Message-----
From: TenTec [mailto:tentec-bounces+w2iy=verizon.net@contesting.com] On
Behalf Of Barry N1EU
Sent: Sunday, March 7, 2021 3:42 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] recommendation for panadaptor for Orion
On Sat, Mar 6, 2021 at 2:04 PM Bob McGraw<rmcgraw@blomand.net> wrote:
The IF output choice is bandwidth limited
while the RF output from the Low Pass Filter is band limited.
Screenshot from a several years back using VE7TK IF output mod on Orion and
LP-PAN: shorturl.at/swMQR
Screenshot from a several years back using similar IF output mod on Omni6
and RSP-1: shorturl.at/aes37 and shorturl.at/eqxES
Just sharing these to give an idea on what kind of bandwidth you might
expect using this method.
73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec