Hello,
I have put the installation instructions at the link below in PDF. Very
sorry for the terrible quality but these were done on a phone in 15 seconds
(not near a scanner). If you look at the IF/AF board and compare them to
the photos, I think you probably could figure out if it has been applied.
Or you can use the last page photos on a scope to see whether the response
is right.
https://drive.google.com/file/d/1M7vD5wh5isUSqBDB2AIutP2qelkMtbVv/view?usp=sharing
73
Phil W1PJE
On Thu, Apr 8, 2021 at 10:51 AM Ken Koval <kakoval@cox.net> wrote:
> I just obtained a very nice Omni 6 Plus and was surprised to find an
> Inrad 756 filter installed. Is there an easy way to find if the
> previous owner also installed the Inrad Audio Filter Mod which they sell
> for $15? I have no problem buying the mod from Inrad, but do not want
> to do so if one is already installed. Thanks.
>
> K9PGC
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
----
Phil Erickson
phil.erickson@gmail.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|