TenTec
[Top] [All Lists]

Re: [TenTec] Little problem with Omni D display

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Little problem with Omni D display
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 30 Apr 2021 13:03:46 -0400
List-post: <mailto:tentec@contesting.com>
check the diodes and then transistors. The counter chip doesn’t have the 
presets inside. 

Does your model have the WARC bands installed? It might have 30 meters, but 
it’s a coin toss if it has the other two WARC bands since they came out later 
than the 30 meter band


Mike, WB8VGE
www.theheathkitshop.com



> On Apr 30, 2021, at 12:48 PM, Jon Iza <jon.iza@gmail.com> wrote:
> 
> Mike, you are wright. It is the C model, as it has the WARC bands.
> The presets use diodes and three transistors. I have exchanged the
> counter chip but results are the same.
> jon, ea2sn
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>