Thanks, Vic.
I’ll try that.
Rick
WO8L
Sent from my iPhone
> On May 10, 2021, at 5:59 AM, Vic Klein via TenTec <tentec@contesting.com>
> wrote:
>
> The 705 mic is pretty hot, compared to others like the 707, and I needed to
> turn the hardware mic gain control down from 100% to 12% to use it. After
> that, the settings for mic gain, SSB band width, and equalizer were the same
> as I use with the 707 as I recall. Without adjusting that mic gain the 705
> vastly overloads that first amplifier which is before the software mic gain
> that you control from the front panel. That hardware gain is the pot under
> the front panel on the right side and turns CCW for maximum.
>
> 73, =Vic=
> WA4THR
> ---------------------------------------------------------------------------
> To: tentec@contesting.com
> Subject: [TenTec] Mic
> From: Rick Cochran via TenTec <tentec@contesting.com>
> Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Date: Sun, 9 May 2021 19:36:50 -0400
> List-post: <mailto:tentec@contesting.com>
>
> I've found an old Ten Tec 705 mic which I'm trying to use with an Omni VII.
>
> However, I got a report of "fuzzy" audio but it was understandable.
>
> What are good settings for mic gain, ssb tx band with, tx equalizer and
> speech
> processor?
>
> Thanks,
>
> Rick
> WO8L
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|