Hi Michael,
How do you have the keying connected? Are you driving it with a Ten-Tec
transceiver and using the full QSK keying loop? Or are you using a
different method? Does the amplifier just not get keyed on at all?
N6KB
On Fri, Sep 23, 2022 at 5:21 PM Michael Tortorella via TenTec <
tentec@contesting.com> wrote:
> Thank you to everyone for the thoughtful replies. Mainly the amp is not
> switching properly. When I got it, it did not pass through properly when
> the
> power was off, so I dug into the vacuum relay board and found some loose
> RCA
> connectors. That cleared up, but switching still did not follow the CW
> input
> ( ave not tried it on SSB because I can't find my mic :-) ). I had a spare
> control board so I replaced that but have not had that on the air yet. I
> asked for repair advice because I am afraid that if the replacement control
> board does not do the trick I am not sure what to do next. I'll report
> back
> as soon as I get to try the new setup. Meanwhile thanks again to everyone
> for your thoughts and advice.
> 73, Michael W2IY
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|