Hi Garry -
Not sure if the C22 uses the same size as the Corsair II, but it seems
possible. The Corsair II uses a 0.050 inch hexagonal screw.
Thanks for the QSO yesterday and for trying to pull my 2 watts out of the
noise. I was using the K2, but hope to be on the Corsair II soon - it's
currently on the bench with a TX issue to fix.
73/73,
Andrew NV1B
..
On Fri, Oct 21, 2022 at 3:47 PM Garry Nichols <garrnich@gmail.com> wrote:
> Does anyone know what size the tiny set screws that hold the knobs on are?
> They measure about 1 mm for the hex opening but that is an estimate.
>
> My rig is #666 in case there was a change across the production run.
>
> Are they metric or English?
>
> TU,
>
> Garry WA1GWH
> near Syracuse, NY
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|