That is, what does the dial read when WWV is zero-beat at 5, 10, or 15
MHz? Which sideband are you using? Does the zero-beat change if you are
in LSB vs USB? (or even CW?)
On Sat, Dec 31, 2022 at 7:33 PM Marcus Florido <k4vbb@live.com> wrote:
> Scott,
>
> You never told us if it was 100Hz too high in frequency (i.e. 14.250.000
> on the dial transmits at 14.250.100), or if it's the other way around.
> ________________________________
> From: TenTec <tentec-bounces+k4vbb=live.com@contesting.com> on behalf of
> Scott Sheppard <scott.vy1co@gmail.com>
> Sent: Saturday, December 31, 2022 5:48 PM
> To: tentec@contesting.com <tentec@contesting.com>
> Subject: Re: [TenTec] [Ten Tec] Orion 2 100hz off
>
> Thanks very much for your response Marcus. That took some time and analysis
> on your part...I am awaiting the new caps for the A9 board so I may do that
> first and see what happens from there. I am suspecting that since I am
> never that lucky, it's like the tcxo but I may be surprised!
>
> Thanks again, and I will report back on progress...
>
> Scott. Vy1co
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|