Hi, Andrew,
There is an adjustment to make the Rx and TX frequencies the same when
the OFFSET is turned off. Adjust trimpot R16 on the Control Board in
accordance with the instructions on page 3-59.
If you don't have the manual, you can download it from Ten Tec here:
https://www.tentec.com/obsolete-product-documentation-list/
With R16 adjusted correctly, there should be no offset between receive
and transmit unless the offset tuning is turned on.
73,
Bob WB2VUF
On 5/31/2024 8:29 AM, Andrew Alleyne wrote:
Greetings,
What I did today with the OMNI.D 546 was to set the transmitt frequency while
transmitting 7.188, then I used the OFFSET to clarify the receive. Reports
were good, I was received well on my transmit frequency 7.188
Not sure if this is normal operating practice with the OMNI.D but is appear to
work.
Await comments.
8P5AJ
Andrew
73
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
This email has been checked for viruses by Avast antivirus software.
www.avast.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|