I would like the fan kit Ken. How should I pay you?
Tnx, Mike Cumbo, ND4S
Sent from Mail for Windows
From: Ken, W8EK
Sent: Tuesday, July 23, 2024 9:53 AM
To: TenTec List at contesting
Subject: [TenTec] TenTec Xcvr, Filter, Mic and more FS
TenTec Orion Transceiver, Filter,
Microphone, Fan, and more For Sale:
.
TenTec Orion 565 HF Transceiver:
-
Features:
.
Full dual receive capability
.
Bandwidth, AGC, PBT, Hi-Lo Cut, AF and
RF Gain, attenuator, DSP NR and notch
filtering independent on each receiver
.
ORION‘s main receiver performance is
unmatched by any other HF transceiver.
.
590 receive IF-DSP bandwidth filters
(100–6000 Hz, 10 Hz steps)
.
Up to six crystal filters in the main receiver
.
The sub receiver has 590 filters independent
of the main receiver filtering
.
Continuous real-time spectrum display
.
Rated 100% duty cycle, 100 watts output
.
Nine adaptive DSP noise reduction filters
.
Dual noise blankers
.
Voice keyer and CW memory keyer built-in
-
This one looks very close to new, and works the same.
No defects. Pristine!
Includes power cord, and paper work, in
original box for $925.
.
I have a variety of TenTec filters available.
All of them work as they should and also look
fine, as if that matters for an internal filter.
.
This filter is used in TenTec rigs
in the 9 MHz IF. This includes the Orion I,
as well as Omni series A, B, and C; Omni V,
Omni VI, Argosy, Paragon, and maybe others.
While it will fit the original Orion,
it does not fit the Orion II.
InRad 762 premium filter
600 Hz wide, CW, $125
.
TenTec Hand Microphone:
This mic is similar to the TenTec model
700, although I do not find that number
on it. It is black plastic case, with
PTT switch. It is an electret mic, with
great frequency response, and a 4 pin
mic plug. $30
.
Heat Sink Fan
This fan goes on the back of virtually all of
TenTec's 100 watt rigs. It plugs into an extra
12 V DC socket on the back of the rig. This fan
keeps some air moving, and greatly prolongs the
life of the rig. $40
.
XLR Cables
All of these cables have a very nice rubber
covered cord, with a 3 pin female XLR
connector on one end.
About 8 feet long, with male 3 pin XLR
connector on other end (extension
cable) $28
20 feet long, extension cable (as above),
still in package, new. $35
About 25 feet long, extension cable (as
above), $35
About 8 feet long, with 1/4 inch mono plug
on the other end. $25
About 8 feet long, with nothing on the
other end. $20
.
Female 3 pin XLR to 1/4 inch plug. $10
.
I also have many other accessories available
such as many different types of microphones,
HTs, VHF and UHF rigs, HF and VHF/UHF antennas,
connectors, miscellaneous accessories, etc.
Just too many to list here.
Please e-mail your requests.
.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|