At 05:00 PM 10/22/96 -0400, you wrote:
>
>Just for the heck of it!
>A flashback to 1995:
> ----------
>From: Randy Thompson
>To: CQ-Contest Reflector
>Subject: Beverage kit
> ----------------------------------------------------------------------------
> --
>I have been amused by all the discussion regarding whether Beverages
>should be made of copper or aluminum or steel wire. Copper seems to be
>the wire of choice and doesn't cost that much anyway.
Flashing back myself........
Ah Randy, you preach the gospel of truth! I have been saying basically the
same for years...there "aint" no reason to make it anymore difficult than it
need to be!
Only suggestion is to make sure the resistors are carbon, not wire wound and
"pot" them with electrician's putty to wx proof them. Good job!
73 Craig, soon to be.....
Craig Clark
soon to be ex-NX1G
send me e-mail and I'll put you on our mailing list
Radio Bookstore
Books for Amateur Radio, SWL and CB Radio Operators
(603) 899 6957
(603) 899 6826 fax
PO Box 209
Rindge, NH 03461
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|