Topband
[Top] [All Lists]

TopBand: Cap for inverted-L... -Reply

To: <topband@contesting.com>
Subject: TopBand: Cap for inverted-L... -Reply
From: hwardsil@wolfenet.com (Ward Silver)
Date: Thu, 9 Jan 1997 07:27:18 -0800 (PST)
On Wed, 8 Jan 1997, MARK TOUSSAINT wrote:

> 
> Remember that adding length to the inverted L will help, but most
> important is that the vertical portion be as long as possible. All you'll be
> doing by adding length to the horizontal portion is making a bigger cap.
> hat. Good luck, Mark AJ1X
> 

Not completely true - by adding horizontal length *beyond a quarter-wave*,
the current maximum is moved "up" the vertical section.  If the wire was
one-half wavelength long, for example, the current maximum would be at the
wire's midpoint.  If the L is exactly one-quarter wavelength long, the
current point is at ground level.  Raising the current maximum away from
the ground should reduce ground losses and improve low-angle radiation.

How far the current maximum should be raised depends on how long the
vertical section is.  I would model the L with different horizontal
lengths and see how the pattern changes - expecting that adding length
would first improve low-angle radiation and then start to fill in the
high-angle pattern as more current begins to flow in the horizontal
section.  I would also expect that there would be a fairly large range of
vertical/horizontal ratios for which the
pattern changes very little.

73, Ward N0AX


--
FAQ on WWW:               http://www.contesting.com/topband.html
Submissions:              topband@contesting.com
Administrative requests:  topband-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>