Hello Topbanders,
The weather has warmed up and I am already working on the shunt fed tower
radials. I am using copper radials connected to an aluminum bar using
stainless hardware (copper does not touch aluminum). Question - how do I get
a low resistance connection from the aluminum bar to the Rohn 45 tower? Is a
tight aluminum to galvanized joint sufficient? Would a jumper to a tower bolt
help? Any ideas?
Please respond to k5tt@contesting.com or the reflector.
Jim, K5TT
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|