>From all what I read and experienced what is really the basic difference
between the sloper and the
shunt fed tower?
You can modify the radiation diagram in a half sloper adding a sloper
director or reflector.
This system has a low R component (abt 15 ohm) and a very high Jw (abt 1900
ohm) component at the feeding point, calculated for my own system here. As
far as I use the same sloper for 80 PH, 80 CW and
160 metre, a matching box at the feeding point should be switched
eletrically in this case.
I tune 80 PH, 80 CW and 160 be adding coils and wires at the sloper wire
ends.
Did anyone have tried something similar ?
73
Egon Boehm
PY2BW
mailto:egon@virtual-net.com.br
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|