Hello, Gentlemen:
I am making plans to start implementing a beverage at my QTH. I live in
a subdivision where antenna restrictions are not enforced at all.
Everyone knows I'm a ham and it's cool. My setup is as follows:
Inverted V up HIGH in a tree for transmit.
ZJ "Beverage Box" mtd on an 8' rod 150' away from the V. Coax into
shack - 9913 in sealed conduit.
As you all may know, the Bev Box can be ordered with a preamp. Mine has
the preamp.
At night, I plan to stretch 580 feet of wire ON THE GROUND out across
the street and into a park.
Connect, of course, one end to the Bev Box ...
I will then terminate with undetermined resistance into a 4' ground rod
at the far end.
I have a couple of questions:
The resistance that I measure at the feedpoint of the beverage is 820
Ohms. Does the termination resistor need to also be 820 Ohms? Or.....
If it is determined that I need an exceptionally low resistance at the
terminating end (like 10 ohms), do I need to take steps to insure that
my feedpoint R matches that low resistance value ??
And lastly....How's performance from a beverage on the ground,
terminated "correctly", into a preamp? Anybody have experience with
such an arrangement?
Thanks, Gents -- I so much enjoy the discussions held on this group --
I've learned so much !!
73 TUL
Mitch Alexander KG9DB
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|