Greetings to all, and a happy Holiday season.
Once again, for the good of all recieve antenna inputs and radios
in radioland: The best $50 you'll ever spend!
The Front End Saver
C & S Engineering
9229 Goldenrod Dr.
Ft. Wayne, IN 46835
(219) 485-1458
VC and VISA welcomed
http://home1.gte.net/crlewis/
Usual disclaimers...no connection whatever.
However, I am a satisifed customer. Their little box is available in
kit or finished form.
At 09:07 PM 12/23/98 -0500, KEN CARUSO wrote:
>
>
> Just a reminder to all using the FT1000D, the aux receive input is not
>well protected from excessive RF on its input. In an attempt to slightly
>improve my rx antenna situation I connected up a relatively low 160M-40M
>trap dipole to its input. On my small suburban lot the dipole is within 20'
>of the Inv L. Even though I was observing over 10W impinging upon it, prior
>to connecting it to the aux receive input, I had assumed the radio would
>open the line when transmitting. It does not and it took less than one
>character to smoke my 12db pad (and as a consequence my 18db selection
>also).
>
> I was fortunate I didn't take out more of the front end.
>
> Two nights before SP, aarrghh....
>
> Ken
>WO1N
>
>--
>FAQ on WWW: http://www.contesting.com/topband.html
>Submissions: topband@contesting.com
>Administrative requests: topband-REQUEST@contesting.com
>Problems: owner-topband@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|