Thanks to everyone that replied to my question below. Answers ranged from no
interaction to huge interaction the consensus seemed to be that there will be
some problems. Since I do not use the loop to much anymore I think it comes
down. I am more interested in the best performance possible from the beverage
than trying to reach some sort of compromise. I plan on using one of KD9SV's
products for antenna switching and front end protection so I was not to worried
about that aspect but was most concerned with noise pickup in the beverage due
to the interaction. Thanks again to all.
73's
Harry - W0PIY
----- Original Message -----
From: Harry Williams
To: topband
Sent: 10/29/2003 06:28
Subject: Topband: Interaction between loop and beverage
I am putting up a 2 wire beverage. Part of it will run directly below a 160M
full wave horizontal loop. The loop is about 25 ft above the beverage. Will
the loop degrade the performance of the beverage and if so how do I correct
it short of taking down?
73's
Harry - W0PIY
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|