Topband
[Top] [All Lists]

Re: Topband: Non-inductive resistors.

To: "Joe Wilkowski" <k8fc@k8fc.com>, <topband@contesting.com>
Subject: Re: Topband: Non-inductive resistors.
From: "Michael Tope" <W4EF@dellroy.com>
Date: Fri, 19 Dec 2003 23:19:47 -0800
List-post: <mailto:topband@contesting.com>
Joe,

Don't forget the Ohmite OX/OY series ceramic composition resistors
(page 677 of the Digi-Key Sept-Dec 2002 catalog). The 2 watt parts (OY
series) are $1.00 each, come in low values (<1K ohm), and carry a
750VAC x 80 joule rating.

I used them on the terminations for a pair of K9AY loop and they have
held up fine for over a year.

73 de Mike, W4EF......................................


> :: Try Digikey  www.digikey.com  Navigate to this part number after some
research at Ohmite http://www.digikey.com/scripts/DkSearch/dksus.dll?  These
are non-inductive 2.5 watt high energy absorbing ceramic axial lead
resistors.  They do not have any values below 1 k so it would take 4 2.2 k
resistors for each termination.  Resistor cost $9.25 each US.  Part number
for these is AX22GK.
>




_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>