| To: | <topband@contesting.com> |
|---|---|
| Subject: | Topband: 450 ohm ladder line used as 2W Beverages |
| From: | "Larry Emery" <k1uo@prexar.com> |
| Date: | Fri, 19 Mar 2004 18:24:05 -0500 |
| List-post: | <mailto:topband@contesting.com> |
What is a good way to support this stuff over an 880ft run? What orientation is best, wires vertical or horizontal with ground, or does it even matter. What is the purpose of twisting every 10 or 20 feet as mentioned in ON4UN's handbook? OK...enough for now...don't want to explode with incoming knowledge! 73 Larry K1UO _______________________________________________ Topband mailing list Topband@contesting.com http://lists.contesting.com/mailman/listinfo/topband |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Topband: Modeling a shunt fed tower with EZNEC, Earl W Cunningham |
|---|---|
| Next by Date: | RE: Topband: Modeling a shunt fed tower with EZNEC, W6IZT |
| Previous by Thread: | Topband: RE: Topband Digest, Vol 15, Issue 30, John Dunnington |
| Next by Thread: | RE: Topband: 450 ohm ladder line used as 2W Beverages, W6IZT |
| Indexes: | [Date] [Thread] [Top] [All Lists] |