>I have a 1/4 wave vert with 8 raised radials the feed point
>is 8 ft off the
> ground it is fed with 600 ohm open wire line would there
> be any advantage by
> installing ferrite cores to the radial side of the feed
> line where the feed
> line meets the 16 radials i have tried this and what i
> have observed is the
> swr does not change but am able to couple more power to
> the antenna given the
> same amount of drive to the amplifier as with out the
> cores installed...any
> thoughts about this
In every measurement I've made, and these are FS
measurements where ONLY the antenna being tested is changed
and nothing else, not choking the feedline cost somewhere
around 1dB in field strength. That is with a coaxial feed.
I don't know why you would want to feed an unbalanced
antenna with balanced line without a balun Ray. I certainly
would not put beads over the ground lead alone. I'd put a
good choke or current balun at the feedpoint so the balanced
line stayed balanced.
73 Tom
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|