Topband
[Top] [All Lists]

Re: Topband: Inverted L Proximity to RX Antennas

To: topband@contesting.com
Subject: Re: Topband: Inverted L Proximity to RX Antennas
From: Brendan Minish <ei6iz.brendan@gmail.com>
Date: Thu, 17 Feb 2011 13:00:12 +0000
List-post: <topband@contesting.com">mailto:topband@contesting.com>
I know it's a different answer... but 

Be careful about RF coming back in on the RX antenna to the radio, Some
radios have issues with even quite low levels (~100mW) comiing in the RX
antenna port. 
the internal isolation may on the face of it appear good enough but any
residual leakage is occurring into low level stages that may be in the
TX chain with 20 to 40dB gain, add in an external linear and even a
small amount of RF being picked up by the TX antenna may be enough to
seriously degrade the quality of you transmitted signal. In particular
look out for any change in ALC action with the RX antenna connected as
this is a sure sign that all is not well 

 


On Wed, 2011-02-16 at 13:25 -0500, k8qm@nc.rr.com wrote:
> All,
> 
> I know it is important to keep RX antennas like flags, pennants and K9AYs as 
> far away from TX antennas as possible. In the case of a quarter wave inverted 
> L with approximately 50 feet vertical is it as important to keep the RX 
> antennas away from the horizontal section as the vertical section?
> 
> Thanks for any guidance.
> 
> Regards,
> 
> George (K8QM)
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK

-- 
73
Brendan EI6IZ 

_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK

<Prev in Thread] Current Thread [Next in Thread>