Dan
A couple of thoughts...
When transmitting, is the RCS-10 antenna switch inadvertantly changing
(switching) antennas (ports) during the transition from receive to transmit,
possibly RF getting into the switching circuit causing this ? Do you lose the
12VDC to the switch when changing from receive to transmit ? Are you trying to
support semi-break-in with the RCS-10 ?
The ratings on this switch are fairly good. 16 amps, 1200 volts. I would think
that it would need to be feeding an open or a short to fail this quickly at
this power level or switching at full power.
Paul - WB2NMI
----- Original Message -----
From: Dan Bookwalter <n8dcj@yahoo.com>
To: topband@contesting.com
Sent: Sat, 31 Dec 2011 17:34:09 -0500 (EST)
Subject: Topband: More Inv-L matching issues.... BIGGER ISSUE
Ok...
I went and added 9 more radials the SWR is now at 1.2:1 after some adjusting of
the air variable....
well , i decided to see how the amp (Alpha 374A) loaded into the antenna , I
keyed down with maybe 500 watts and everything went dead again in less that 1
second. So it now appears that I have smoked another relay in the RCS-10 .
One thing about this configuration is that the base of the antenna is about 16"
from the RCS-10 , is this too close ? I can probably move it so that it is
about 4' away if that is the issue.... I cant afford to keep destroying relays
and such....
thoughts ?
Dan N8DCJ
________________________________
-----Original Message-----
From: topband-bounces@contesting.com [mailto:topband-bounces@contesting.com]
On Behalf Of Dan Bookwalter
Sent: Saturday, December 31, 2011 2:41 PM
To: topband@contesting.com
Subject: Topband: More Inv-L matching issues....
well about a month ago i put up my Inv-L , it is now ~165ft , I have an air
variable in series , and 12 radials anywhere from 150-250ft long ( going out
to add more as soon as i am done typing this). my SWR wasn't too bad maybe
1.7:1 at the best. Two nights ago I added an amplifier to the mix ~700w ,
well to make a long story short I smoked one of the relays in my RCS-10 , I
am now not too sure what to do , I don't want to keep blowing out relays in
the RCS-10.
I had several responses back then regarding matching etc... , but , in my
haste i seem to have deleted them :-(
so here i am again asking for advice...
any help greatly appreciated
Dan N8DCJ
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1901 / Virus Database: 2109/4714 - Release Date: 12/31/11
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|