Dan,
What happens when you *DO* connect the L directly to your coax run and use
your radio?
IE: is SWR ok? The antenna works? (you make contacts easily).
Sounds like RF getting into the Remote switch.
Mike
AA
Mike, Coreen & Corey Smith
699 Rte 616 Keswick Ridge
NB
Canada
E6L 1T1
----- Original Message -----
From: Dan Bookwalter
To: topband@contesting.com
Sent: Tuesday, January 24, 2012 4:48 PM
Subject: Topband: Inv-L Issues - Still no luck
Ok , I am having a real problem here that I haven't been able to solve
yet.
I have an inverted L out at the tower that is about 160' long , 70ft
vertical the rest sort of horiz , slopes down.... I have one run of RG213 to
the RCS-10 remote antenna switch which is at the tower , it was very close
to the L , so i moved it so that it is now about 4 ft away from the L, I
also grounded it. what is happening is that when i transmit , even 1 dit at
about 10 watts something happens out at the switch , the radio goes silent ,
then after a minute or two it usually starts to come back. it only affects
the port that the L is attached to , my Windom is on port 2 and it works
fine , so it isnt the radio , the L also works just fine on other bands , I
replaced 2 PL-259's and changed the coax that goes from the switch to the L
, I do not know what else to do at this point other than at night when i
want to use 160 go out to the tower and connect the feedline directly to the
L. It happens no matter what port i have the L connected to...
any ideas ?
Dan
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.454 / Virus Database: 271.1.1/4162 - Release Date: 01/23/12
19:34:00
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|