The original stuff used acetic acid for the curing process. The II
variety does not. I still prefer to use it over acrylic spray or
especially vinyl tape. That way you don't get it directly on the metal
and it is easier to free up if changes are necessary.
73,
Dave Heil K8MN
On 8/5/2012 14 35, Tom W8JI wrote:
>
>> found that GE Silicone II Sealant, which is fine for outside, to work very
>> well for covering solder joints.
>>
>> I've purchased it in many local hardware stores. It runs around $6 per
>> tube.
>>
>> It cures in just a few hours, is rain resistant and does not affect the
>> solder
>> joint.
>>
>> There were reports years ago that the curing process would impact the
>> solder
>> but I have not found that to be true.
>
> Me, too. I know people say it causes problems, but I've yet to ever see any
> problem or sign of any problem. I've used it or similar for many years. :-)
>
>> It can be peeled off and I've always found the solder joint just as clean
>> as
>> it was when it was first done even after several years.
>
> Same here.
>
> 73 Tom
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2012.0.2197 / Virus Database: 2437/5176 - Release Date: 08/04/12
>
>
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2197 / Virus Database: 2437/5176 - Release Date: 08/04/12
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|