I've just used strips of sheet copper cut with
snips for "flat" wire. I purchased a sheet from a
Hobby Lobby store. Their ads usually include a
20% off coupon good for just about any
one item at their stores.
73,
Charlie, N0TT
On Mon, 16 Sep 2013 01:39:46 +0000 (UTC) wa3mej@comcast.net writes:
>
>
> I know this may be a little off topic BUT.... I am looking for some
> flat wired to wind an edge wound inductor. I am guessing that it
> needs to be something like an eight of an inch on the narrow side by
> maybe three eights of in inch on the long or flat side. This will
> allow my roller wheel to ride on the inside of the inductor to
> change inductance.
>
> Now for the rub. I cant find anyone that makes wire like this. I
> know it is made because others have made inductors using this kind
> of wire. Oh and it has to be silver plated if possible.
>
> These coils are to be part of a balanced tuner and yes I know I can
> purchase coils but I want consistency since I am going to build
> several of these units.
>
> Any and all help appreciated.
>
> Thanks Jim WA3MEJ
>
>
> http://www.qsl.net/wa3mej/index.htm
> _________________
> Topband Reflector
_________________
Topband Reflector
|