Topband
[Top] [All Lists]

Re: Topband: KD9SV-OK1RR relays ???

To: Top Band List List <topband@contesting.com>
Subject: Re: Topband: KD9SV-OK1RR relays ???
From: wb6rse1@mac.com
Date: Sun, 30 Aug 2015 14:51:43 -0700
List-post: <topband@contesting.com">mailto:topband@contesting.com>
The mast of my RX flag is 20-25 ft from my 160/80m shunt fed tower. I run a KW+ 
on the low bands. I use an Array Solutions AS-RXFEP RF Limiter (aka FES etc.) 
in line with the flag at the rig’s RX Ant IN. The RXFEP uses a gas discharge 
tube and a pair of matching transformers with back-to-back diodes in between.

I favor this passive approach which avoids having to deal with any relay and 
sequencing issues when QSK.

https://www.arraysolutions.com/Products/as_rxfep.htm

The “manual” link shows the schematic.

I also use a W3NQN BCB filter (from AS).

I have had my K3’s COR (carrier operated relay) trigger on 80m depending upon 
the orientation of the flag. A not so obvious RF path of some sort. This issue 
was solved by placing the BCB ahead of the FEP.

I recommend the RXFEP if you want a passive non-relay solution. If you have 
strong local BC stations, the W3NQN brick wall BCB filter works wonders.

Steve WB6RSE




_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>