Where can I find a schematic for a good high pass filter that rolls off at
1700 kHz?
I can't even have back to back diodes here on Beverages without amplifiers,
because the accumulation of hundreds and hundreds of BCB stations sum to
more than two volts peak.
With a 10dB gain amp, I can light 12 volt lamps.
I cure this with a very simple basic 5 pole filter that has 3dB roll off at
1600 kHz. Unless you have something on top of you at upper AM BCB, you don't
have to worry about 1700 kHz plus.
You need two inductors and three silver micas, and get a good preamp. Do not
put it at the antenna. It just adds to overload issues. My amps are all in
the shack, and some of the cables are 3000 foot long mixes of F6, F11, and
only a few have significant hardline runs.
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|