Stan,
With shunt feed I would gain the 18 foot mast with the yagis, the total
overall height is 108 feet.
I haven't really considered shunt feeding. I see your point of the
wires with an L in proximity to other
antennas. That was a worry I had with the 40 meter yagi and the L. I
will look into shunt feeding. I have ON4UN's book, probably should
start there to bone up. Any other resources to learn abut shunt feeding ?
The top band archives probably has a lot of discussions about shunt
feeding also.
thanks Stan,
Bob
K6UJ
On 12/18/15 1:36 AM, Stan Stockton wrote:
Bob,
There is no reason I can think of to not shunt feed the tower as it is with
either ground radials or elevated radials. An inverted L isn't as good as a
vertical for DX and you would just be adding clutter and horizontal wires in
proximity to your other antennas. Shunt feeding a tower is very, very simple.
73... Stan, K5GO
On Dec 17, 2015, at 8:06 PM, Robert Harmon <k6uj@pacbell.net> wrote:
I am planning an install of a 160M inverted L and would like critique from you
top banders.
I was originally planning a separate tower for 160 but my XYL has squashed the
idea :-)
My tower is 90 feet fully extended with a 18 foot mast currently used for a
Force 12 WARC plus 10/15 beam
on top and a N6BT DXU-32, 2EL 40 and 3EL 20 12 feet below.
At the top of the top section I have a 10 foot fiberglass pole I plan to extend
out to support the vertical, so it will be 10 feet away from the tower.
I am thinking of feeding the vertical and having 4 elevated radials at the 14
foot level.
So the vertical wire will about 76 feet long.
I am wondering if I would be better lowering the feedpoint & radial tie ins
down from 14 feet say to 8 feet and have more length in the vertical portion of the
L or better to have the 14 feet elevation for the radials ?
Also the horizontal leg of the L on top will be about 5 feet below the 40/20
yagi only 10 feet out from the tower,
do you think this is OK as far as interaction between the yagi and the 160 L ?
Anything else I should consider ?
I have never had a decent 160 antenna, just hoping I can work something out
with my existing situation
thanks in advance,
Bob
K6UJ
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|