Don't bash yourself too hard Ken. I have had my share of oops, what did
I do ? :-)
It will be interesting to see what happens when you disconnect the feedline.
Bob
K6Uj
On 4/26/16 6:33 PM, Ken K6MR wrote:
Yes I did put that in. I think. I modeled the whole thing and duplicated the phasing line lengths
and crossover at the feedpoint. Although once I get it down I’m going to recheck that again.
After my blunder with the resistors there’s no telling what else I’ve done wrong.
Thanks,
Ken K6MR
From: Lee STRAHAN<mailto:k7tjr@msn.com>
Sent: Tuesday, April 26, 2016 18:16
To: topband@contesting.com<mailto:topband@contesting.com>
Subject: Topband: Waller Flag construction and performance
Ken, did you remember the 180 degree phase inversion needed on the Waller
flag.
It will act like a very large signal level single loop if not.
Lee K7TJR
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|