I use the DX-Engineering RTR-1 which is the easiest and best solution
IHMO. It even provides protection by locking the RX portion out on
Transmit by loop the PTT amp cable. I have two of these units now and
use them on all the Icom radios. They even have a special momentary
toggle for check the TX antenna for A/B RX tests. Must have been
designed by a thoughtful amateur.
Herb Schoenbohm, KV4FZ
On 9/22/2016 1:27 PM, Gabriel - EA6VQ wrote:
Boxbe <https://www.boxbe.com/overview> This message is eligible for
Automatic Cleanup! (ea6vq_ml@dxmaps.com) Add cleanup rule
<https://www.boxbe.com/popup?url=https%3A%2F%2Fwww.boxbe.com%2Fcleanup%3Fkey%3DbWoHeC7pcbMUu0epOCb6Ejoa%252FB6Azx76O8Ul9yLporc%253D%26token%3DiFYrT9om%252FM5XuGlDaEkYKpQBVzQxFSe0f9d16uTj6WUe30BAe%252FPRAjaENMoTrdt800zwujz7gQnhMeSw6hRUc7wj6oiwilNi%252Fg5hieIQ61qbUyfRwmm3d0QnEbr7DWy3EczLJRz60Dw%253D&tc_serial=26887604545&tc_rand=249032270&utm_source=stf&utm_medium=email&utm_campaign=ANNO_CLEANUP_ADD&utm_content=001>
| More info
<http://blog.boxbe.com/general/boxbe-automatic-cleanup?tc_serial=26887604545&tc_rand=249032270&utm_source=stf&utm_medium=email&utm_campaign=ANNO_CLEANUP_ADD&utm_content=001>
I will appreciate your advice in the best (but simple) way to switch between RX
and TX antennas for a transceiver that does not have a separate RX antenna
input.
The system should be able to switch from RX antenna to TX antenna when PTT is
applied (and vice versa) but also allow to switch between the two antennas
during reception in order to compare.
I have thought about using a coax relay as I do switch the VHF preamps, but I
think it's switching will possibly too slow and some RF could flow to the RX
antenna, causing damage.
Any ideas will be welcome!
73. Gabriel – EA6VQ
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|