Thanks everyone. I plan to try it this weekend.
73
Art NK8X
ᐧ
On Mon, Oct 17, 2016 at 1:56 PM, Ray Benny <rayn6vr@cableone.net> wrote:
>
> ----- Original Message -----
> From: Mike Furrey <mikefurrey@att.net>
> To: Art Snapper <art@nk8x.net>, 160 <topband@contesting.com>
> Sent: Mon, 17 Oct 2016 12:32:20 -0400 (EDT)
> Subject: Re: Topband: inv. L
>
> Hi Art,Yes, I have done that and am doing that. I use tall trees as
> supports and the 160 inverted L goes up one side of the tree then bent over
> horizontally to another tree over yonder. From the same feed point, the 80
> meter section goes up the other side of the same tree and the top actually
> folds over an upper limb down to the tie point. I have had the antennas
> separate and had them from the same feed point as I do now and I have not
> seen much, if any difference in performance. With 600 watts output I have
> about 165 countries on 160 and about 220 on 80 from a small suburban lot in
> Houston. I just installed the same antenna in TN and it has worked quite
> well there. I feed it through a ferrite bead balun and I have one elevated
> (up about 20') per band.Hope this helps. 73, Mike WA5POK
>
>
> On Monday, October 17, 2016 10:17 AM, Art Snapper <art@nk8x.net>
> wrote:
>
>
> I was considering adding a second vertical element to my 160 inverted L.
> This one would be roughly a quarter wave tall for use on 80.
>
> I tried modelling in Eznec, but wasn't comfortable with the results. I may
> have screwed it up.
>
> Has anyone tried it for real? Is it a big compromise on either band? Would
> a switch at the feedpoint have any benefit?
>
> My inverted L has about 50 radials.
>
> 73
> Art NK8X
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
> Art,
>
> I do the same. I have a 75 ft irrigation pipe vertical w/top hat wires and
> use an base inductor to match it on 160m. I also have a 14 inch standoff
> arm attached at the 67 ft point and run a #10 ga drop wire, I call it, to
> the base. This wire is not attached to the standoff arm, so it becomes a
> 1/4 wave vertical for 80m. It is held away from the irrigation pipe with
> flat fiberglass insulators.
>
> I feed this wire thru a separate feed line and inductor to match it on
> 80m. I do have plenty of ferrites on both coax feed lines. Before operating
> on 80m, I do have to short the irrigation pipe (160m vertical) to ground.
> As of now, I have to go to the base and physically short the vertical with
> a ground jumper.
>
> I have about 100 radials at the base of the vertical(s) and feel I have a
> good signal working DX on both bands.
>
> Ray,
> N6VR
>
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|