Topband
[Top] [All Lists]

Re: Topband: Ladder line Beverage Installation

To: FritzOAQ <fritz@k4oaq.com>
Subject: Re: Topband: Ladder line Beverage Installation
From: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
Date: Fri, 12 May 2017 21:48:41 -0400
List-post: <topband@contesting.com">mailto:topband@contesting.com>
wood screws via the small slots in the posts 


Sent from my iPhone

> On May 12, 2017, at 9:36 PM, FritzOAQ <fritz@k4oaq.com> wrote:
> 
> Mike,
> 
> What do you connect to the PVC pipe to hold the wires?
> 
> 
> 
> Herb,
> 
> How do you connect the paint sticks to the posts?
> 
> 
> 
> Fritz K4OAQ
> 
> 
> 
> 
> 
> I drive the metals posts into the ground and slide a 10 foot section of gray
> 
> 
> PVC pipe over the post for my supports.
> 
> 
> 
> Mike N2MS
> 
> 
> 
> 
> 
> DXE sells some nifty ladder insulators designed for wooden posts. They are
> listed at $13.95 for a bag of 25. (DXE P/N DXE-LL-LNS) In my case I wanted
> to use metal fence supports with wood on the top for an easier installation
> with a 3 lb maul rather than digging holes for the post supports. While
> pushing my cart through Home Depot one day I stumbling upon paint stir
> sticks in the paint section for .99 cents for a package of three. They are
> made of pine and are 33 inches long and appear very durable being almost 1/4
> inch thick. They can flex a bit but hard to break even over your knee. Much
> to my surprise the DXE Beverage insulator snaps right on to the top portion
> where the paint mixer would normally put his hand. Although not really
> necessary a small wood screw would prevent any insulator from unsnapping in
> high winds. A coat ofThompson's Water Seal on the paint stick is also an
> option. Mounting these insulators in this fashion would bring the ladder
> line in a vertical position with respect to ground. With a half twist ever
> 70 feet I think this would enhance the performance and not degrade it in
> anyway. If I am wrong with that the Beverage gurus might possiblycorrect me.
> 
> 
> 
> I know this is sort of a trivia post but I was amazed at how easily the DXE
> insulator snapped on the paint stick. Also if wooden 2X2's are an option for
> support they can be placed in line of the Beverage field first. Then a screw
> gun can zip these paint sticks in place as required.
> 
> 
> 
> Herb Schoenbohm, KV4FZ
> 
> 
> 
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>