Several members of this forum rightfully objected to my post "doubting"
VU2GSM's use of remote RX in QSOs since he had openly admitted to same
in his correspondence. Since I view my e-mail in reverse chronological
order, I had read Paul's post and responded before seeing the posts by
VE6WZ with the links to his correspondence with VU2GSM. I apologize for
my hasty response and resultant ambiguity.
Nevertheless, I have worked Kanti a couple of times on each of 30, 40
and 80M. The 30M QSOs took place generally around his SR and early
evening here, and I have heard him many times in that time frame on that
band. I use a two element quad and either 100 or 200W output on that
band, and his reports of my signal, 559, are consistent with those
conditions. When I worked him on 80M, I began a correspondence with
him. His response to that initial e-mail was "Yes i got you clearly and
you were overriding QSB." That sure sounds like he was copying me
directly. Further, for some reason when I had QSLed him directly, I had
omitted our 80M QSO and had to request a second QSL from him via
e-mail. In that exchange there was not the slightest hint of his using
remote RX. Subsequently, because he knew I had an Expert 2K amp here,
we had several detailed e-mail exchanges to discuss the set-up of his
newly acquired 1.3K amp. Again, there was absolutely no hint of using
remote RX.
It appears that he does use remote RX at times, but a review of the
times and signal reports for all our QSOs strongly support direct, long
haul reception.
Again, I apologize for any ambiguity in my previous post.
73, Joe
K2XX
*From:* "Joe Giacobello, K2XX" <k2xx@swva.net>
*Date:* Monday, January 15, 2018 10:37 AM
*To:* Paul Christensen <w9ac@arrl.net>
*CC:* 'Steve Babcock' <ve6wz@shaw.ca>, 'topband' <topband@contesting.com>
*Subject:* Topband: VU2GSM webSDR use
Like Paul, I seriously doubt that Kanti is using a remote receiver. I
have worked him on 30, 40 and 80M and have had occasional
correspondence with him regarding his relatively recently acquired
Expert 1.3K amp. The signal reports he has given me seem appropriate
for the times and band conditions at the time of the QSOs. I'm
confident that had he been using a remote RX, it would have come up in
our correspondence.
73, Joe
K2XX
*From:* Paul Christensen <w9ac@arrl.net>
*Date:* Sunday, January 14, 2018 12:29 PM
*To:* "'Steve Babcock'" <ve6wz@shaw.ca>, "'topband'"
<topband@contesting.com>
*Subject:* Topband: VU2GSM webSDR use
No doubt some ops are using WebSDR on receive, but in this case, I am
skeptical of the skepticism. Here's why:
I routinely work VU2GSM on 40m GL-LP in the early morning hours on a
210-degree bearing from FL to VU. He is consistently S9, peaking +10
dB on my Elecraft K3. The remote station I share with N4CC is in
Hilliard, FL just east of the St. Mary's River. Our antenna is a
full-size 4 el. M2 40m OWA at 140 ft AGL.
On the 210 deg. bearing, the land slopes almost immediately into the
river valley. VU2GSM's solid signals aren't an isolated event; he is
that strong most of the LP season. VU2GSM cannot be detected on my
backyard dipole at my home QTH 30 miles to the south in Jacksonville.
The dipole is up 35 ft. AGL. When I say he can't be detected, I mean
there's no trace on the dipole whatsoever, not even a blip that rises
above the SDR noise floor. That's to be expected on a low dipole if
the arriving angle is skimming the horizon.
According to HFTA, the statistical mode from FL to VU is 1 degree
above the horizon. The sloping terrain accounts for much of VU2GSM's
solid signals into the station. Forget 4-square arrays over good soil,
Forget stacked arrays up to 200 ft AGL. Apart from verticals on salt
water, nothing else compares with high horizonal antennas into sloping
terrain when the statistical mode is 1 degree above the horizon. When
VU2GSM is +10/S9 here, I am certain he is hearing me on his dipole and
he doesn't need WebSDR.
When I hear other NA stations calling VU2GSM on 40m, he cannot hear
many, if not most of them. Of those he picks out, he struggles to copy
unless they're from stations with excellent antenna systems - like
those in the RHR group. So, if VU2GSM is routinely using WebSDR on 40m
receive, his operating habits are not reflective of such claims.
Paul, W9AC
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of
Steve Babcock
Sent: Sunday, January 14, 2018 10:03 AM
To: topband <topband@contesting.com>
Cc: Larry D Brailean <ve5ua@mcsnet.ca>; Don Moman VE6JY
<ve6jy.1@gmail.com>
Subject: Topband: VU2GSM webSDR use
I have been "sitting" on this for a few weeks wondering if I should
share this information, but after seeing some spots yesterday for
VU2GSM on 160m, I decided that others may appreciate it.
I know I would.
If you have worked Kanti, VU2GSM recently on the low bands...40, 80 or
160 you should be aware that he was most likely RX using a NA webSDR.
The links below are PDF copies of email correspondence with Kanti
confirming that this is routine for him.The emails are between both
VE5UA, myself and VU2GSM. (Please read the email threads from the
"bottom up" to be chronological.)
https://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharinghttps://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharing
<https://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharinghttps://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharing>
https://drive.google.com/file/d/1MdZFLJrwcBs-vHh0PNZc2DSevu3lrwcg/view?usp=sharing
<https://drive.google.com/file/d/1MdZFLJrwcBs-vHh0PNZc2DSevu3lrwcg/view?usp=sharing>
To be clear, I do not judge Kanti for his desire to augment his rx,
and do not think it is wrong. If he chooses to use Ham radio this way
that is his choice. However, I myself do not wish to include a "half"
QSO toward my own (personal) DXCC count, and perhaps others will feel
the same hence this email. I also don't judge others that are good
with such webSDR QSOs since each has his own goals and objectives.
Here is some background. I have been working VU2GSM frequently and
with ease on 40m in the morning and evening. He would respond almost
immediately to my calls which seemed odd. More typical is Rakash
VU2RAK who has a great signal but usually can't copy me, though we
have QSOd a few times when conditions are exceptional.
While at a local ham lunch, I mentioned this, and Don VE6JY said that
Kanti is often logged into his webSDR. The following week I copied
VU2GSM on 80m in the evening with very light copy with my 2el Yagi and
1000' beverage (diversity rx with K3). He answered immediately and we
had a QSO. I was suspicious. I emailed Don VE6JY and he confirmed that
at that time Kanti was indeed logged into his SDR.
I deleted the QSO from my log.
This then precipitated the e-mail correspondence which I share on the
attached links.
There is little doubt this is going on all the time, and we will never
know. We can't undo the technology that makes webSDR possible.
There are those who who feel that this destroys the “integrity” of the
DXCC. However, not everyone cares about DXCC.
Kanti is not a villan. He is doing nothing wrong. He is not
“cheating”. In his email correspondence he is very open and
transparent and makes it clear he doesn't chase DXCC, and could care
less about it. Why should he?
From Kanti's perspective, using a webSDR enhances his enjoyment of the
hobby living in RFI polluted Bangalore. For others, a "half-VU" QSO is
better than none and they are happy.
Like others, I spend a great deal of effort optimizing both rx and tx
and someday when I do make the QSO with VU on 80 and hopefully 160, it
will be a true two-way contact. The “buzz” for me is not getting the
country counter in the log, its about knowing that my station made the
contact via radio….both ways…all the way.
The purpose of this email is simply to inform those who have worked
Kanti recently that it is possible/likely that your TX signal was not
actually heard in VU.
73, de Steve ve6wz
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
*From:* Steve Babcock <ve6wz@shaw.ca>
*Date:* Sunday, January 14, 2018 10:03 AM
*To:* topband <topband@contesting.com>
*CC:* Larry D Brailean <ve5ua@mcsnet.ca>, Don Moman VE6JY
<ve6jy.1@gmail.com>
*Subject:* Topband: VU2GSM webSDR use
I have been "sitting" on this for a few weeks wondering if I should share this
information, but after seeing some spots yesterday for VU2GSM on 160m, I decided that
others may appreciate it.
I know I would.
If you have worked Kanti, VU2GSM recently on the low bands...40, 80 or 160 you should be
aware that he was most likely RX using a NA webSDR. The links below are PDF copies of
email correspondence with Kanti confirming that this is routine for him.The emails are
between both VE5UA, myself and VU2GSM. (Please read the email threads from the
"bottom up" to be chronological.)
https://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharinghttps://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharing<https://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharinghttps://drive.google.com/file/d/15n35-1wHPOdWi2Xib7QAQgxkg-hrOujs/view?usp=sharing>
https://drive.google.com/file/d/1MdZFLJrwcBs-vHh0PNZc2DSevu3lrwcg/view?usp=sharing<https://drive.google.com/file/d/1MdZFLJrwcBs-vHh0PNZc2DSevu3lrwcg/view?usp=sharing>
To be clear, I do not judge Kanti for his desire to augment his rx, and do not think it
is wrong. If he chooses to use Ham radio this way that is his choice. However, I myself
do not wish to include a "half" QSO toward my own (personal) DXCC count, and
perhaps others will feel the same hence this email. I also don't judge others that are
good with such webSDR QSOs since each has his own goals and objectives.
Here is some background. I have been working VU2GSM frequently and with ease on
40m in the morning and evening. He would respond almost immediately to my calls
which seemed odd. More typical is Rakash VU2RAK who has a great signal but
usually can't copy me, though we have QSOd a few times when conditions are
exceptional.
While at a local ham lunch, I mentioned this, and Don VE6JY said that Kanti is
often logged into his webSDR. The following week I copied VU2GSM on 80m in the
evening with very light copy with my 2el Yagi and 1000' beverage (diversity rx
with K3). He answered immediately and we had a QSO. I was suspicious. I emailed
Don VE6JY and he confirmed that at that time Kanti was indeed logged into his
SDR.
I deleted the QSO from my log.
This then precipitated the e-mail correspondence which I share on the attached
links.
There is little doubt this is going on all the time, and we will never know. We
can't undo the technology that makes webSDR possible.
There are those who who feel that this destroys the “integrity” of the DXCC.
However, not everyone cares about DXCC.
Kanti is not a villan. He is doing nothing wrong. He is not “cheating”. In his
email correspondence he is very open and transparent and makes it clear he doesn't chase
DXCC, and could care less about it. Why should he?
From Kanti's perspective, using a webSDR enhances his enjoyment of the hobby living in
RFI polluted Bangalore. For others, a "half-VU" QSO is better than none and
they are happy.
Like others, I spend a great deal of effort optimizing both rx and tx and someday when I do make the QSO
with VU on 80 and hopefully 160, it will be a true two-way contact. The “buzz” for me is not
getting the country counter in the log, its about knowing that my station made the contact via
radio….both ways…all the way.
The purpose of this email is simply to inform those who have worked Kanti
recently that it is possible/likely that your TX signal was not actually heard
in VU.
73, de Steve ve6wz
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|