Thanks to everyone who has replied to me, guess I'll never know how good it
would have worked with 3Y0Z cancelled,
Trevor
EI2GLB
----- Original Message -----
From: Stan Stockton <wa5rtg@gmail.com>
To: MR TREVOR DUNNE <ei2glb@eircom.net>
Cc: topband List <topband@contesting.com>
Sent: Fri, 02 Feb 2018 16:20:14 -0000 (GMT)
Subject: Re: Topband: Beverage transformer and testing
Put a 600 ohm resistor or something close across the secondary leads where
the beverage would be connected and hook up an analyzer to the primary
wires and see what you read on your analyzer. Check it from about 1.5 to 5
mhz and you should see a good SWR over that range and more.
73...Stan, ZF9CW
On Fri, Feb 2, 2018 at 10:33 AM, MR TREVOR DUNNE <ei2glb@eircom.net> wrote:
> Hi I know it's probably been covered here hundreds of times but I'm
> looking to make a matching Transformer for a 550ft beverage to 75 ohm coax,
>
> I have so bn73-202 cores
>
> Also how can I test it once it's built
>
> Thanks
> Trevor
> EI2GLB
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|