Topband
[Top] [All Lists]

Topband: FW: Isolated F81 F Barrel Connector

To: <topband@contesting.com>
Subject: Topband: FW: Isolated F81 F Barrel Connector
From: "Paul Christensen" <w9ac@arrl.net>
Date: Sun, 21 Oct 2018 17:01:43 -0400
List-post: <mailto:topband@contesting.com>
Thanks for all the replies.  I failed to mention that the plate is being 
designed in Front Panel Express (FPE) software.  I didn’t think FPE offered 
non-metallic panels.  However, I just took another look at the design menu and 
I was surprised to find they offer panels in an acrylic material called 
“Perspex.”  It’s less expensive to CNC machine and engrave than aluminum, so 
this may be the best option. 

 

Paul, W9AC. 

 

Sent from Outlook <https://aka.ms/qtex0l>  for iOS





On Sun, Oct 21, 2018 at 3:46 PM -0400, "Steve Maki" <lists@oakcom.org 
<mailto:lists@oakcom.org> > wrote:

Can't you just use a non-metallic plate?
 
-Steve K8LX
 
On 10/21/18 15:08 PM, Paul Christensen wrote:
> Google isn't my friend today...
> 
> I am looking for an isolated "F" barrel connector, commonly known as the
> F81.  I am designing an aluminum interface plate for use with a Hi-Z
> 8-circle receive array.  The panel will contain multiple F81 barrel
> connectors that attach to the side of a large PVC tool box with gasket
> weather seal.  An isolated F81 is probably a very odd item since it's a
> connector that's not normally used for baseband signal distribution like
> video and data.
> 
> Each of the RG-6 lines run into a Hi-Z switched phasing box where each line
> is connected to a toroid transformer.  As such, measuring resistance from
> the ground of one antenna port to another shows about 30 ohms resistance,
> necessitating isolation at my connection plate.  The Hi-Z phasing box is
> made of PVC material and each antenna input is isolated by virtue of the
> plastic box.
> 
> In the alternative, I could use isolated BNC or TNC connectors with F
> between-series adapters.   Insulating each F81 with its own insolation strip
> is definitely not an option in this application.  The last option is to run
> all lines directly into the large box and make a direct connection to the
> Hi-Z phasing unit.  However, I would really like the option to disconnect on
> the *outside* of the box so that it can be quickly wheeled in for
> maintenance.
> 
> Thoughts?
> 
> Paul, W9AC
> 
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
> 
 
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector

_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
<Prev in Thread] Current Thread [Next in Thread>