-------- Original Message --------
Subject: Re: Topband: Impedance of inv l?
Date: Sun, 18 Nov 2018 10:55:47 -0500
From: F Z_Bruce <k1fz@myfairpoint.net>
To: ww3s@zoominternet.net, Topband <topband@contesting.com>
That sounds about right. As you put a good ground system under it, that value
will come down, and the efficiency will come up.
Many add extra antenna wire that pushes the current up the wire, this also
raises the impedance, hopefully to near 50 ohms with the right length.
A capacitor (variable, then fixed) in series at the feed point can cancel the
added inductive reactance.
73
Bruce-k1fz
https://www.qsl.net/k1fz/beverage_antenna.html
On Sun, 18 Nov 2018 10:41:36 -0500, WW3S wrote:
What should the Z be for a 1/4 wave inv l, with the radials attached to a
radial plate? Mine seems to be 60 ohms or so....
Sent from my iPad
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|